Revolutionary patent pending technology creates a secure "safety zone" around you making sure your tagged valued item is not forgotten or stolen. Your MONITOR alarms to let you know if your tagged item goes outside of your preset Safety Zone.

STEP 1.

STEP 2.

STEP 3.

STEP 4.

STEP 5.

Your TagAlert™ uses advanced Radio Frequency 'RF' technology that offers exceptional advantages by not requiring the MONITOR and TAG to have direct line of site to work.

However, operation may be affected by the manner in which the MONITOR and TAG are worn on the body or attached to an item. Under certain, conditions the ALERT range may become shorter resulting in false alarms.

1. Put setting on LONG
2. Using a strap to attach the TAG to an item is preferred over direct adhesion to some surfaces (like a cell phone or an iPOD).

3. Adjust location of MONITOR or TAG to be closer to each other. The body can greatly shorten the alert range so try to position the MONITOR and TAG on the same side of the body.
   See examples in diagrams above.
4. If false alarms persist, press SNOOZE to silence alarm for 10 minutes, or turn MONITOR off for 15 seconds and then turn back on.

1. The MONITOR performs best when worn away from your body, such as attached to a purse strap or clipped to a belt loop. Try to avoid attaching many keys to it and putting it in then pocket of your pants
2. To minimize false alarms, keep TAG as close as possible to the MONITOR at all times.
3. Metal objects, such as coins, may cause false alarms if they touch or are located very close to the MONITOR or TAG
4. Test the MONITOR and TAG in the manner they will be worn (example : MONITOR clipped to purse strap or pants belt and TAG on cell phone in pocket or belt holster).

MONITOR does not make a sound even when TAGS are out of range and LED never blinks

1. MONITOR needs to be reset
2. MONITOR batteries are dead

1. Reset MONITOR by removing and installing batteries again
2. Replace MONITOR batteries

1. Both TAGS need to be reset
2. Both TAG batteries are dead

1. Reset both TAGS by removing each battery, wait 10 minutes and install again.
2. Replace each TAG battery

1. One TAG has poor battery contact
2. One of the TAGS has a dead battery

1. Reset bad TAG by removing battery, wait 10 minutes and install again.
2. Replace bad TAG battery

Turn MONITOR on and wait 10 seconds until a beep is heard. Place one TAG into a metal pot and close the lid. If the MONITOR beeps the TAG in the pot is being tracked otherwise the TAG is bad. Remove the TAG from the pot and repeat the process with the other TAG.

Remote Play, Inc. warrants to the original purchaser that this product (TagAlert™), is free from material and workmanship defects when used under normal conditions for a period of one (1) year from the date of purchase. Should the product contain defects in material or workmanship Remote Play, Inc., will repair or replace the product, at our option, free of charge. Purchaser will be responsible for all costs associated with packaging and shipping the product to Remote Play, Inc. Consumer Relations Department at the address noted on front page and all other freight or insurance costs associated with the return. Remote Play, Inc. will bear the cost of shipping the repaired or replaced product to the purchaser. Product should be returned in its original package accompanied by a proof of purchase, either a sales receipt or other proof that the product is within the warranty period. This warranty is void if the owner repairs or modifies the product or the product has been damaged as a result of misuse. This warranty excludes any liability other than that expressly stated previously, including but not limited to, any incidental or inconsequential damages.

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS THAT MAY VARY FROM STATE TO STATE.

Go to the Remote Play web site to register your TagAlert™ warranty web: www.remoteplay.com phone: 800-515-2928

PLEASE READ THE FOLLOWING WARNINGS AND ALL ASSEMBLY AND USE INSTRUCTIONS CAREFULLY BEFORE USING TAGALERT.™ KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.

• The TagAlert™ system is not intended to replace responsible and proper supervision.
• Do not use TagAlert™ on board an airplane. You can turn off the TAG by removing the battery.
• TagAlert™ contains small parts not suitable for children.
• It is essential to check reception regularly. Please see the "Testing System" section for complete instructions.
  
• Check batteries regularly by observing the LED blinking. An audio tone will occur when batteries are low.
  
• RF distance measurements are not accurate and can vary from one locale to the next.
• This product should be serviced only by qualified service personnel at Remote Play, Inc. when:
  • The MONITOR or TAG have fallen
  • Liquid has spilled into the MONITOR or TAG or either unit has fallen into water.
  • The MONITOR or TAG does not appear to operate normally or exhibit a marked change in performance.
• This TAG is not intended for laptop use, the TA-150 model is better suited. Call 800-515-2928 for information on compatibility and buying this model.
• DO NOT attempt to service this product beyond that described in the Troubleshooting section. All other servicing should be referred to qualified personnel at Remote Play.

DO NOT DISASSEMBLE MONITOR OR TAG. THIS WILL VOID THE WARRANTY. NO SERVICEABLE PARTS INSIDE. REFER SERVICING TO REMOTE PLAY CONSUMER RELATIONS 800-515-2928.